Service

Crawl space mold treatment and insulation

White fuzz on the joists and pink insulation on the ground are the same problem showing up two ways: the wood has been wet.

Treating mold on the framing

We check the wood with a moisture meter first. Anything reading above 20 percent is still actively wet, and there's no sense cleaning it until we know why.

Surface mold gets brushed and vacuumed with a HEPA unit, then the joists and subfloor are treated with an antimicrobial made for wood framing. Dark staining often stays behind after the growth is dead. Stain is cosmetic. Soft wood isn't, so we probe every suspicious spot with an awl, and anything that gives goes on the repair list.

One honest limit: we treat crawl spaces. If you have mold in the living area, on drywall or in the HVAC system, you want a licensed remediation company and probably an air test, and we'll tell you that.

Getting the old insulation out

Wet fiberglass is miserable stuff. It holds moisture against the subfloor, gives mice a place to nest and weighs four times what it did dry. We bag it under the house and carry it out so it doesn't travel through your yard in pieces.

Putting insulation back

If the crawl space is being sealed, we insulate the foundation walls with rigid foam board and leave the joists open. The floor ends up warmer because the whole space is closer to house temperature.

If you're keeping the vents open, new batts go back between the joists with proper supports, and we'll be straight with you that they'll have the same life as the last set unless the humidity changes.

Mold and insulation questions

Is mold in a crawl space dangerous?

It can be a problem for people with allergies or asthma, because air from the crawl space rises into the house. It's also a warning about the wood. Mold means the framing has been damp long enough that rot may be next.

Can I spray bleach on crawl space mold?

We'd skip it. Bleach is mostly water, it doesn't soak into wood well, and the mold returns if the humidity stays high. Cleaning has to be followed by drying the space out.

Why is my crawl space insulation falling down?

Fiberglass batts soak up humid air like a sponge. They get heavy, pull loose from the wire hangers and end up on the ground. It happens in nearly every vented crawl space here within 10 to 15 years.

Should crawl space insulation go on the walls or between the joists?

In a sealed crawl space, rigid foam on the walls works better and can't fall. In a vented one, insulation has to stay between the joists, which is one more reason sealing usually wins.

Get someone under your house

Tell us what you're seeing or smelling. We'll call you back to set a time to look.

(423) 522-8225

Call (423) 522-8225